How it Works - Wall Stud Finder - Wood Working Tools

SIMPLICITY IS THE KEY.
FOLLOW THESE SIMPLE STEPS:

Magic Stud Finder Plus

Load the Targets into the Holder.
Apply the Holder horizontally to the wall and move in a sweeping motion as shown at right.
Stop when you hear a CLICK and FEEL the Target release.
Pull the Holder away from the wall as shown. The Targets will stick to the wall like MAGIC!!
Repeat the entire process either above of below the placed Targets to locate the entire stud or to locate more studs.

NOTE: MOST STUDS ARE SPACED 16 INCHES APART HOWEVER, SPACING MAY VARY.
Once the Target locates the first Stud, you can easily load more Targets onto the
Target Holder and mark the rest of your wall as seen in the picture.

Magic Stud Finder Compact

1) Load THE TARGET ( the compact holds one target)
2) Scan the wall same way as above in the illustrations
3) When the stud is located the target dispenses AUTOMATICALLY (it will stick to the wall like magic.)

WARRANTY:

UNPERSENTED, UNCONDITIONAL, LIFETIME WARRANTY ON MANUFATURING DEFECTS. Should there be a manufacturer’s defect, please return with a COPY of your receipt along with your name, address and phone number to the following address:

Biary Innovation Co.
21012 Devonshire St.
Chatsworth, CA 91311

Allow 4 - 6 weeks for delivery of replacement product. Sorry, but warranty for product shipped without a copy of the receipt will not be honored.

WARNINGS & IMPORTANT SAFETY INSTRUCTIONS:

Xtreme Magnet Targets are strong magnets which must be handled with care to avoid personal injury. Fingers and other body parts can get severely pinched between two attracting Targets. NEVER place the “Targets” near ELECTRONIC DEVICES, (especially pacemakers, memory cards, hard drives, etc.) as it may cause loss or malfunction. KEEP OUT OF REACH OF CHILDREN. Small parts pose a choking hazard to small children. Always wear protective eyewear when using tools.